IT 210 Week 3 Check Point Sequential and Selection Processing Control Structure Appendix G
Read the following scenario:
You work for a county court and need to design a program to calculate the total on a speeding tick. Each line of the table in Appendix G in the Course Materials forum indicates a MPH over the speed limit range and corresponding calculations for the fine and court costs for the range. Given a MPH over the speed limit, the fine is calculated by adding the base fine for the MPH over the speed limit range to the over the limit multiplier, the court costs are determined by court cost multiplier, and the total fine is the sum of the fine and the court costs. – Please see Appendix G in the Course Materials forum for more details.
You must use the Selection Control structure to determine the calculation at the different MPH over the speed limit.
Design a program with pseudocode that solves this problem.
Perform a design walkthrough to verify your design.
Post the assignment as an attachment.
Your solution should look like the example provided in Appendix E; it must include the program analysis (process, input, and output) and the pseudocode.